Table of Contents
Advertisement
5060-00x
RIP board removal
See
"RIP board assembly - network, model 5060-002" on page 7-37
network, Model 5060-001" on page 7-37
Warning: Improper RIP board replacement can result in incorrect printer function and significant additional
service time due to loss of data.
Warning: Also if both the RIP and engine boards are being replaced, DO NOT replace both at once. Replace
one board at a time, following appropriate procedures for each.
1.
Remove the outer EMC shield. See
2.
Remove the rear cover. See
3.
Remove the USB connector screw type
4.
Remove the RIP board screw type
5.
Remove the parallel connector (C).
6.
Disconnect all cables from the RIP board and remove the board.
Installation notes
Perform the following steps to install the replacement RIP board:
1.
Turn off the printer.
2.
Install the replacement RIP board.
3.
Turn on the printer.
4.
When the operator panel prompts NV Rip to Eng, choose STOP. This prevents transfer of data from the
RIP board to the engine board.
5.
When the operator panel prompts NV Eng to Rip, choose GO. This transfers data from the engine board to
the RIP board. The printer restarts at this point.
6.
At the READY prompt, print a Menu page and look for the correct printer name and equivalent/updated RIP
code level. The Menu page prints with acceptable print quality indicating calibration data has been properly
preserved.
4-70
Service Manual
for the part number.
"Outer EMC shield removal" on page
"Rear cover removal" on page
"232"
(A).
"232"
(B).
or
"RIP board assembly, non-
4-47.
4-8.
Advertisement
Table of Contents
