Table of Contents
Advertisement
2xx
Primary message
code
251
Paper Jam
Clear Paper Path
Go to
"Autocompensator
service check" on
page 2-114
271
Paper Jam
Clear Paper Path
272
Paper Jam
Clear Paper Path
280
Paper Jam
Clear Paper Path
Secondary message
Description
Leave Job in Finisher
Primary: Media is jammed in the paper path near
the MP Feeder due to an in-line transparency
sensor mismatch. If sheets have been
accumulated to be stapled or offset when the jam
is detected, the printer alternately flashes the
primary and secondary messages to indicate that
all accumulated sheets should not be removed
during the jam clearing procedure.
Secondary: Do not remove accumulated sheets
during the jam clearing procedure. The printer will
not reprint the removed sheets. Also, if the
accumulated sheets are removed, the portion of
the job printed after the jam will not be stapled.
Leave Job in Finisher
Primary: Media is jammed at output Bin 1. Open
the rear door of Bin 1 to access the jam. If sheets
have been accumulated to be stapled or offset
when the jam occurred, the printer alternately
flashes the primary and secondary messages to
indicate that all accumulated sheets not be
removed during the jam clearing procedure.
Secondary: When this message is displayed, do
not remove accumulated sheets during the jam
clearing procedure as the printer will not reprint the
removed sheets. Also, if the accumulated sheets
are removed, the portion of the job printed after the
jam will not be stapled.
Leave Job in Finisher
Primary: Media is jammed in output bin x. Open
the door of output bin x to access the jam. If sheets
have been accumulated to be stapled or offset
when the jam occurred, the printer alternately
flashes the primary and secondary messages to
indicate that all accumulated sheets not be
removed during the jam clearing procedure.
Secondary: When this message is displayed, do
not remove accumulated sheets during the jam
clearing procedure as the printer will not reprint the
removed sheets. Also, if the accumulated sheets
are removed, the portion of the job printed after the
jam will not be stapled.
Leave Job in Finisher
Primary: Paper is jammed in the finisher option,
open the side door or top cover to access the jam.
If sheets have been accumulated to be stapled or
offset when the jam occurred, the printer
alternately flashes the primary and secondary
messages to indicate that all accumulated sheets
not be removed during the jam clearing procedure.
Secondary: When this message is displayed, do
not remove accumulated sheets during the jam
clearing procedure as the printer will not reprint the
removed sheets. Also, if the accumulated sheets
are removed, the portion of the job printed after the
jam will not be stapled.
5060-00x
2-27
Diagnostic information
Advertisement
Table of Contents
