Configure Passive-Interface - Dell Force10 C150 Configuration Manual

Configure Passive-Interface

Use the following command to suppress the interface's participation on an OSPFv3 interface. This
command stops the router from sending updates on that interface.
Command Syntax
passive-interface
{type slot/port}
To enable both receiving and sending routing updates, enter the
When you configure a passive interface, the
"passive interface" to indicate that hello packets are not transmitted on that interface.
Command Mode
CONF-IPV6-ROUTER-OSPF
Usage
Specify whether some or all some of the interfaces will be
passive.
Interface identifies the specific interface that will be
passive.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information
(e.g. passive-interface gi 2/1).
For a port channel, enter the keyword port-channel
•
followed by a number from 1 to 255 for TeraScale and
ExaScale, 1 to 32 for EtherScale (e.g. passive-interface
po 100
)
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information ( e.g. passive-interface ten 2/3).
For a VLAN, enter the keyword vlan followed by a
•
number from 1 to 4094 (e.g. passive-interface vlan
2222).
E-Series ExaScale platforms support 4094 VLANs
with FTOS version 8.2.1.0 and later. Earlier
ExaScale supports 2094 VLANS.
no passive-interface interface
show ipv6 ospf interface
Open Shortest Path First (OSPFv2 and OSPFv3) | 729
command adds the words
command.