Configuring Transmit And Receive Mode - Dell Force10 C150 Configuration Manual

Figure 26-13. Configuring LLDPDU Transmit and Receive Mode
R1(conf)#protocol lldp
R1(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
no disable
R1(conf-lldp)#mode ?
rx
tx
R1(conf-lldp)#mode tx
R1(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
mode tx
no disable
R1(conf-lldp)#no mode
R1(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
no disable
R1(conf-lldp)#

Configuring Transmit and Receive Mode

Once LLDP is enabled, Dell Force10 systems transmit and receive LLDPDUs by default. You can
configure the system—at CONFIGURATION level or INTERFACE level—to transmit only by executing
the command
no mode
596 | Link Layer Discovery Protocol
Rx only
Tx only
mode tx
, or receive only by executing the command
command (Figure 26-14).
mode rx
. Return to the default with the