Snmp Over Ipv6; Show Ipv6 Information - Dell Force10 C150 Configuration Manual

Command Syntax
telnet
ipv6 address

SNMP over IPv6

SNMP is
Simple Network Management Protocol (SNMP) can be configured over IPv6 transport so that an IPv6 host
can perform SNMP queries and receive SNMP notifications from a device running FTOS IPv6. The FTOS
SNMP-server commands for IPv6 have been extended to support IPv6. Refer to the SNMP and SYSLOG
chapter in the
• snmp-server host
• snmp-server user ipv6
• snmp-server community ipv6
• snmp-server community access-list-name ipv6
• snmp-server group ipv6
• snmp-server group access-list-name ipv6

Show IPv6 Information

All of the following show commands are supported on platforms:
View specific IPv6 configuration with the following commands.
Command Syntax
show ipv6 ?
500 | IPv6 Addressing
Command Mode
EXEC or
EXEC Privileged
IPv6 addresses are normally written as eight groups of four hexadecimal digits,
where each group is separated by a colon (:). Omitting zeros is accepted as
described in
c e s
supported on platforms
FTOS Command Line Interface Reference
Purpose
Enter the IPv6 Address for the device.
ipv6 address : x:x:x:x::x
mask : prefix length 0-128
Addressing earlier in this chapter.
for more information regarding SNMP commands.
Command Mode Purpose
EXEC or List the IPv6 show options
EXEC Privileged
c e s