Create A Virtual Stack Unit On An S-Series Stack; Display Information About An S-Series Stack - Dell Force10 C150 Configuration Manual

Create a Virtual Stack Unit on an S-Series Stack

Use virtual stack units to configure ports on the stack before adding a new unit, or to prevent FTOS from
assigning a particular stack-number.
Task
Create a virtual stack unit.

Display Information about an S-Series Stack

Task
Display for stack-identity, status, and
hardware information on every unit in a
stack (Figure 50-18).
Display most of the information in
system
, but in a more convenient tabular
form (Figure 50-19).
Display the same information in
system
, but only for the specified unit
(Figure 50-19).
Display topology and stack link status for
the entire stack. The available options
show system stack-port
separate the
output into topology information from link
status information
1036 | Stacking S-Series Switches
show
show
(Figure 50-19).
Command Syntax
stack-unit provision
Command Syntax
show system
show system brief
show system stack-unit
show system stack-ports
[
Command Mode
CONFIGURATION
Command Mode
EXEC Privilege
EXEC Privilege
EXEC Privilege
status topology
| ] EXEC Privilege