Dell Force10 C150 Configuration Manual page 579

Step Task
2
Activate the necessary ports
administratively
3
Enable fefd globally
show fefd
Entering the
interface.
Figure 25-11. Show FEFD global outputs
FTOS#show fefd
FEFD is globally 'ON', interval is 3 seconds, mode is 'Normal'.
INTERFACE MODE
Gi 1/0 Normal
Gi 1/1 Normal
Gi 1/2 Normal
Gi 1/3 Normal
FTOS#show run fefd
!
fefd-global mode normal
fefd-global interval 3
Enable FEFD on an Interface
Entering the command
FEFD mode, supplement the
aggressive normal
{ |
To disable FEFD protocol on one interface, enter the command
Disabling an interface will shut down all protocols working on that interface's connected line, and will not
delete your previous FEFD configuration which can be enabled again at any time.
Step Task
1
Setup two or more connected
interfaces for Layer 2 or Layer 3 use
2
Activate the necessary ports
administratively
3
Enable FEFD on each interface
Command Syntax
no shutdown
fefd
{
mode
command in EXEC privilege mode displays information about the state of each
INTERVAL
(second)
3
3
3
3
fefd
in INTERFACE mode enables FEFD on a per interface basis. To change the
fefd
command in INTERFACE mode by entering the command
}].
Command Syntax
ip address ip
address
no shutdown
fefd
{
interval
Command Mode
INTERFACE
interval
| CONFIGURATION
}
STATE
Bi-directional
Admin Shutdown
Admin Shutdown
Admin Shutdown
fefd disable
Command Mode
INTERFACE
switchport
,
INTERFACE
disable |
INTERFACE
mode
| }
fefd mode
[
in INTERFACE mode.
Layer 2 | 579