Management Access On S-Series Stacks - Dell Force10 C150 Configuration Manual

Ftos configuration guide ftos 8.4.2.7 e-series terascale, c-series, s-series (s50/s25)

Hide thumbs Also See for Force10 C150:

Table of Contents

Figure 50-6. Adding a Standalone with a Lower MAC Address but Higher Priority to a Stack—After

-------------------------------STANDALONE AFTER CONNECTION----------------------------------

Standalone#00:18:27: %STKUNIT2-M:CP %CHMGR-5-STACKUNITDETECTED: Stack unit 0 present

00:18:27: %STKUNIT2-M:CP %CHMGR-5-STACKUNITDETECTED: Stack unit 1 present

00:18:40: %STKUNIT2-M:CP %CHMGR-2-STACKUNIT_DOWN: Stack unit 0 down - card removed

00:18:40: %STKUNIT2-M:CP %CHMGR-2-STACKUNIT_DOWN: Stack unit 1 down - card removed

00:19:30: %STKUNIT2-M:CP %POLLMGR-2-ALT_STACK_UNIT_STATE: Alternate Stack-unit i

00:19:30: %STKUNIT2-M:CP %CHMGR-5-STACKUNITDETECTED: Stack unit 0 present

00:19:30: %STKUNIT2-M:CP %CHMGR-5-STACKUNITDETECTED: Stack unit 1 present

[remaining bootup messages omitted]

------------------------------------STACK AFTER CONNECTION----------------------------------

Stack#3w1d15h: %STKUNIT1-M:CP %POLLMGR-2-ALT_STACK_UNIT_STATE: Alternate Stack-unit is not

3w1d15h: %STKUNIT1-M:CP %CHMGR-5-STACKUNITDETECTED: Stack unit 2 present

Going for reboot. Reason is Stack merge

3w1d15h: %STKUNIT1-M:CP %CHMGR-2-STACK_UNIT_DOWN: Stack-unit 0 down - card removed

[bootup messages omitted]

Stack#show system brief

Stack MAC : 00:01:e8:d5:ef:81

---------------------------------------------------------------------------

Management Access on S-Series Stacks

You can access the stack via the console port or VTY line.

Console access: You may access the stack through the console port of the stack manager only. Like a

standby RPM, the console port of the standby unit does not provide management capability; only a

limited number of commands are available. Member units provide a severely limited set of commands,

Remote access: You may access the stack with SNMP, SSH, or Telnet through any enabled, Layer 3

interface on any stack unit. There is no dedicated management port or management route table.

Stacking S-Series Switches | 1025

Show Quick Links

Table of Contents