Displaying Tracked Objects - Dell Force10 C150 Configuration Manual

Displaying Tracked Objects

You can display the currently configured objects used to track Layer 2 and Layer 3 interfaces, and IPv4
and IPv6 routes, by entering the following
show track
•
vrf
vrf-name
Use the
Layer 3 interfaces, IPv4 or IPv6 routes, or a VRF instance. You can also display the currently config-
ured per-protocol resolution values used to scale route metrics when tracking metric thresholds.
Figure 31-9. Command Example:
FTOS#show track
Track 1
IP route 23.0.0.0/8 reachability
Reachability is Down (route not in route table)
2 changes, last change 00:16:08
Tracked by:
Track 2
IPv6 route 2040::/64 metric threshold
Metric threshold is Up (STATIC/0/0)
5 changes, last change 00:02:16
Metric threshold down 255 up 254
First-hop interface is GigabitEthernet 13/2
Tracked by:
VRRP GigabitEthernet 7/30 IPv6 VRID 1
Track 3
IPv6 route 2050::/64 reachability
Reachability is Up (STATIC)
5 changes, last change 00:02:16
First-hop interface is GigabitEthernet 13/2
Tracked by:
VRRP GigabitEthernet 7/30 IPv6 VRID 1
Track 4
Interface GigabitEthernet 13/4 ip routing
IP routing is Up
3 changes, last change 00:03:30
Tracked by:
Track 5
IP route 192.168.0.0/24 reachability, Vrf: red
Reachability is Up (CONNECTED)
3 changes, last change 00:02:55
First-hop interface is GigabitEthernet 13/4
Tracked by:
Figure 31-10. Command Example:
Router# show track brief
ResId
1
2
3
688 | Object Tracking
[ [ brief ] | interface [ brief ] [ vrf
object-id
[ brief ] | brief ]
show track
command to display the configuration and status of currently tracked Layer 2 or
Resource
IP route reachability
Interface line-protocol
Interface ip routing
show
commands:
] | ip route [ brief ] [ vrf
vrf-name
show track
show track brief
Parameter
10.16.0.0/16
Ethernet0/2
VLAN100
] | resolution |
vrf-name
State LastChange
Up 00:01:08
Down 00:05:00
Up 01:10:05