Show Interfaces Configured - Dell Force10 C150 Configuration Manual

Ftos configuration guide ftos 8.4.2.7 e-series terascale, c-series, s-series (s50/s25)

Hide thumbs Also See for Force10 C150:

Manual (57 pages)

Manual (66 pages)

Quick start manual (33 pages)

Table of Contents

Figure 20-1. show interfaces Command Example

FTOS#show interfaces tengigabitethernet 1/0

TenGigabitEthernet 1/0 is up, line protocol is up

Hardware is Force10Eth, address is 00:01:e8:05:f3:6a

Current address is 00:01:e8:05:f3:6a

Pluggable media present, XFP type is 10GBASE-LR.

Medium is MultiRate, Wavelength is 1310nm

XFP receive power reading is -3.7685

Interface index is 67436603

Internet address is 65.113.24.238/28

MTU 1554 bytes, IP MTU 1500 bytes

LineSpeed 10000 Mbit, Mode full duplex, Master

ARP type: ARPA, ARP Timeout 04:00:00

Last clearing of "show interface" counters 00:09:54

Queueing strategy: fifo

Input Statistics:

0 packets, 0 bytes

0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts

0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts

0 Multicasts, 0 Broadcasts

show ip interfaces brief

enabled for Layer 3 data transmission. In

since an IP address has been assigned to it and the interface's status is operationally up.

Figure 20-2. show ip interfaces brief Command Example (Partial)

FTOS#show ip interface brief

GigabitEthernet 1/0

GigabitEthernet 1/1

GigabitEthernet 1/2

GigabitEthernet 1/3

GigabitEthernet 1/4

GigabitEthernet 1/5

GigabitEthernet 1/6

GigabitEthernet 1/7

GigabitEthernet 1/8

show interfaces configured

interfaces. In

20-2, GigabitEthernet interface 1/5 is in Layer 3 mode since an IP address has been

assigned to it and the interface's status is operationally up.

To determine which physical interfaces are available, use the

mode. This command displays all physical interfaces available on the line cards.

command in the EXEC Privilege mode to view which interfaces are

20-2, GigabitEthernet interface 1/5 is in Layer 3 mode

OK? Method Status