Bulk Configuration; Interface Range - Dell Force10 C150 Configuration Manual

dest-ip
•
lsb
• — always uses the least significant bit of the hash key to compute the egress port
To change to another method, use the following command in the CONFIGURATION mode:
Command Syntax
hash-algorithm ecmp { crc-upper } |
{ dest-ip } | { lsb }
For more on load-balancing, see "Equal Cost Multipath and Link Aggregation Frequently Asked
Questions" in the E-Series FAQ section (login required) of iSupport:
https://www.force10networks.com/CSPortal20/KnowledgeBase/ToolTips.aspx

Bulk Configuration

Bulk configuration enables you to determine if interfaces are present, for physical interfaces, or,
configured, for logical interfaces.

Interface Range

An interface range is a set of interfaces to which other commands may be applied, and may be created if
there is at least one valid interface within the range. Bulk configuration excludes from configuration any
non-existing interfaces from an interface range. A default VLAN may be configured only if the interface
range being configured consists of only VLAN ports.
interface range
The
applied to that range of interfaces.
The interface range prompt offers the interface (with slot and port information) for valid interfaces. The
maximum size of an interface range prompt is 32. If the prompt size exceeds this maximum, it displays (...)
at the end of the output.
Note: Non-existing interfaces are excluded from interface range prompt. In the following example,
Tengigabit 3/0 and VLAN 1000 do not exist.
Note: When creating an interface range, interfaces appear in the order they were entered and are not
sorted.
show range
The
all interfaces that have been validated under the interface range context.
440 | Interfaces
— uses destination IP address as part of the hash key
Command Mode
CONFIGURATION
command allows you to create an interface range allowing other commands to be
command is available under interface range mode. This command allows you to display
Purpose
Change to another algorithm.