Cp Software Exceptions; Command History - Dell Force10 C150 Configuration Manual

When the trace messages are being saved on reload,
Message 9 Saving Trace Messages
Starting to save trace messages... Done.
The CP and LP trace file names at chassis reload are:
• CP: reload_traceRPM0_CP
• LP: reload_traceLP[0-7]
Figure 60-8.
FTOS#cd /flash/TRACE_LOG_DIR/TRACE_LAST_BOOT
FTOS#dir
hw_traceLP0.0
hw_traceLP0.1
hw_traceLP2.0
hw_traceLP2.1
hw_traceLP2.2

CP software exceptions

When a RPM resets due to a software exception, the linecard trace files are saved to
TRACE_LOG_DIR
The CP and LP trace file names in the case of a software exception are:
• CP: failure_trace_RPM1_CP
• LP: failure_trace_RPM1_LP[0-7]
For systems with a single RPM, the linecard traces are saved on the failed RPM itself.
For systems with dual RPM, linecard trace logs are saved when the CP, RP1, or RP2 crashes. The linecard
trace logs are saved on the new Primary RPM. The linecard trace file name identifies the failed RPM. For
example, if RPM0 fails the trace files saved in RPM1 with filename as

Command history

The command-history trace feature captures all commands entered by all users of the system with a time
stamp and writes these messages to a dedicated trace log buffer. When the
command is entered, the system displays a trace message for each executed command. No password
information is saved to the file. The trace messages are not saved to a file or directory on the internal
system flash.
To view the command-history trace, use the
1178 | C-Series Debugging and Diagnostics
Directory example
TRACE_LAST_BOOT
hw_traceLP2.3
hw_traceLP2.4
hw_traceRPM0_CP.0
hw_traceRPM0_CP.1
hw_traceRPM0_CP.2
directory.
Message 9 is displayed.
hw_traceRPM0_CP.3 reload_traceLP6
hw_traceRPM0_CP.4 reload_traceRPM0_CP
reload_traceLP0
reload_traceLP2
reload_traceLP3
show command-history
command, as shown in
flash:/
failure_trace_RPM0_LP1
.
show command-history
Figure 60-9.