Automatic Trace Log Updates; Save A Hardware Log To A File On The Flash - Dell Force10 C150 Configuration Manual
Ftos configuration guide ftos 8.4.2.7 e-series terascale, c-series, s-series (s50/s25)
Hide thumbs
Also See for Force10 C150:
- Manual (57 pages) ,
- Manual (66 pages) ,
- Quick start manual (33 pages)
Table of Contents
Advertisement
TRACE_LOG_DIR/TRACE_CURR_BOOT
The
command from the
Note: At reload this directory is renamed to
empty
flash:/TRACE_LOG_DIR/TRACE_CURR_BOOT
Automatic trace log updates
The system automatically saves trace files to the internal flash. The files are saved to the
TRACE_LOG_DIR directory on the flash, and are named so that they can be viewed in a logical order. The
first automatic CP software trace file is labeled
trace file is labeled
overwriting them (sw_trace_RPM0CP.1, and so on until sw_trace_RPM0CP.4, hw_trace_RPM0CP.1, and
so on until hw_trace_RPM0CP.4).
These files are saved in
flash:/TRACE_LOG_DIR/TRACE_LAST_BOOT
to
directory is created.
Trace file hw_trace_RPM0CP.0 is not overwritten so that chassis bootup message are preserved.
The CP and LP trace file names are:
•
CP [SW trace] : sw_trace_RPM0CP.0, sw_trace_RPM0CP.1, sw_trace_RPM0CP.2,
sw_trace_RPM0CP.3 and sw_trace_RPM0CP.4
•
CP [HW trace] : hw_trace_RPM0CP.0, hw_trace_RPM0CP.1, hw_trace_RPM0CP.2,
hw_trace_RPM0CP.3 and hw_trace_RPM0CP.4
•
LP [SW trace] : sw_trace_LP[0-7].0, sw_trace_LP[0-7].1, sw_trace_LP[0-7].2, sw_trace_LP[0-7].3
and sw_trace_LP[0-7].4
•
LP [HW trace] : hw_trace_LP[0-7].0, hw_trace_LP[0-7].1, hw_trace_LP[0-7].2, hw_trace_LP[0-7].3
and hw_trace_LP[0-7].4
Trace files are saved in the directory
this directory is renamed
TRACE_LOG_DIR/TRACE_CURR_BOOT
Save a hardware log to a file on the flash
The RPM and line card trace logs are enabled by default. The trace logs are saved automatically but you
can save the contents of a buffer manually with the CLI. The files are named the same whether they are
saved automatically or manually.
1176
|
C-Series Debugging and Diagnostics
directory can be reached by FTP or by using the
flash://TRACE_LOG_DIR
directory.
hw_trace_RPM0CP.0
. Up to five trace logs are saved before the system begins
flash:/TRACE_LOG_DIR/TRACE_CURR_BOOT
flash:/TRACE_LOG_DIR/TRACE_CURR_BOOT
flash:/TRACE_LOG_DIR/TRACE_LAST_BOOT
directory is created.
flash:/TRACE_LOG_DIR/TRACE_LAST_BOOT
directory is created.
sw_trace_RPM0CP.0,
and the first automatic CP hardware
. At reload this directory is renamed
flash:/TRACE_LOG_DIR/TRACE_CURR_BOOT
and an empty
, and an empty
show file
and a new
. Upon a system reload
flash:/
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
