Configuration Requirements; Configuration Task List For Ospfv2 (Ospf For Ipv4) - Dell Force10 C150 Configuration Manual

To ensure equal intervals between the routers, manually set the dead interval of the Dell Force10 router to
match the Cisco configuration. Use the command "ip ospf dead-interval <x>" in interface mode:
Figure 32-6. Command Example: ip ospf intervals
FTOS(conf)#int gi 2/2
FTOS(conf-if-gi-2/2)#ip ospf hello-interval 20
FTOS(conf-if-gi-2/2)#ip ospf dead-interval 80
FTOS(conf-if-gi-2/2)#
Figure 32-7. OSPF Configuration with intervals set
FTOS (conf-if-gi-2/2)#ip ospf dead-interval 20
FTOS (conf-if-gi-2/2)#do show ip os int gi1/3
GigabitEthernet 2/2 is up, line protocol is up
Internet Address 20.0.0.1/24, Area 0
Process ID 10, Router ID 1.1.1.2, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) 1.1.1.2, Interface address 30.0.0.1
Backup Designated Router (ID) 1.1.1.1, Interface address 30.0.0.2
Timer intervals configured, Hello 20, Dead 80, Wait 20, Retransmit 5
Hello due in 00:00:04
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 1.1.1.1 (Backup Designated Router)
FTOS (conf-if-gi-2/2)#
For more information regarding this functionality or for assistance, go to
support
.

Configuration Requirements

The interfaces must be in Layer-3 mode (assigned an IP address) and enabled so that they can send and
receive traffic. The OSPF process must know about these interfaces. To make the OSPF process aware of
these interfaces, they must be assigned to OSPF areas.
OSPF must be configured GLOBALLY on the system in CONFIGURATION mode.
OSPF features and functions are assigned to each router using the CONFIG-INTERFACE commands for
each interface.
Note: By default, OSPF is disabled

Configuration Task List for OSPFv2 (OSPF for IPv4)

Open Shortest Path First version 2 (OSPF for IPv4)
1. Configure a physical interface. Assign an IP address, physical or loopback, to the interface to enable
Layer 3 routing.
704 | Open Shortest Path First (OSPFv2 and OSPFv3)
Dead Interval
Set at 4x
Hello Interval
www.force10networks.com/
is supported on platforms
Dead Interval
Set at 4x
Hello Interval
c e s