Dell Force10 C150 Configuration Manual page 1140

To track an interface or configured object for a virtual group, use the
Task
Monitor an interface or a configured object and,
optionally, reconfigure the cost value to be
subtracted from the VRRP group priority if the
status of the tracked object goes DOWN.
(Optional) Display the configuration and UP or
DOWN state of tracked objects, including the
client (VRRP group) that is tracking an object's
state.
(Optional) Display the configuration and UP or
DOWN state of tracked interfaces and objects in
VRRP groups, including the time since the last
change in an object's state.
(Optional) Display the configuration of tracked
objects in VRRP groups on a specified interface.
he sum of all the costs for all tracked interfaces and objects must be less than or equal to the
Note: T
configured priority of the VRRP group.
Figure 58-14. Command Example:
FTOS(conf-if-gi-1/1)#vrrp-group 111
FTOS(conf-if-gi-1/1-vrid-111)#track gigabitethernet 1/2
FTOS(conf-if-gi-1/1-vrid-111)#
Figure 58-15. Command Example:
FTOS(conf-if-gi-1/1-vrid-111)#show configuration
!
vrrp-group 111
advertise-interval 10
authentication-type simple 7 387a7f2df5969da4
no preempt
priority 255
track GigabitEthernet 1/2
virtual-address 10.10.10.1
virtual-address 10.10.10.2
virtual-address 10.10.10.3
virtual-address 10.10.10.10
FTOS(conf-if-gi-1/1-vrid-111)#
1140 | Virtual Router Redundancy Protocol (VRRP)
Command Syntax
track {
|
interface object-id
[ priority-cost
]
cost
Valid object IDs are from 1 to 65535.
Cost range: 1-254. Default: 10
show track
show vrrp
show running-config interface
interface
track interface
in VRID mode
show configuration
track
command in the VRRP mode:
Command Mode
} INTERFACE-VRID
EXEC
EXEC Privilege
EXEC
EXEC Privilege
EXEC
EXEC Privilege