The Wan Trap Managers Table; Editing The Trap Managers Table - Avaya P330 User Manual

* Note: Each X330WAN expansion module has its own Trap
The WAN Trap Managers table is used to configure the IP addresses of the
trap managers and their trap reporting statuses for WAN traps. Traps
include routing, WAN, and frame relay traps.
Frame relay traps can only be enabled or disabled per X330WAN
expansion module. If frame relay traps are enabled, all enabled managers
receive frame relay traps. If frame relay traps are disabled, no managers
will receive frame relay traps.
To enable frame relay traps on the X330WAN expansion module, check
the
on the X330WAN expansion module, uncheck the
relay traps
The following table provides a list of trap types, their associated icons, and
their descriptions.
For information on adding and removing trap managers and editing their
trap reporting statuses, refer to
page
132
Managers table, which can be used to configure IP addresses
and trap managers for the specific module. Device wide trap
settings do not apply to traps from X330WAN expansion
modules in the device.
Enable standard frame relay traps
checkbox.
Table 14-3. WAN Trap Types
Icon Trap
Trap Enable
Router Traps
WAN Traps
133.
checkbox. To disable frame relay traps
Enable standard frame
Description
Enables trap reporting for the selected
manager.
A group of traps that report router
detected events.
A group of traps that report problems
with the WAN interface and cable.
"Editing the Trap Managers Table" on
Avaya P330 Manager User Guide