Avaya P330 User Manual page 54

QoS Parameters
QoS can be controlled either locally or remotely. If control is remote, the
information for these fields comes from the gatekeeper. If control is local,
you can configure the
The following table lists the QoS parameters and their descriptions.
In addition, the operational status of the MGP and any faults on the MGP
appear at the bottom of the MGP Config tab.
The MGC Config tab provides information about the Media Gateway
Controller's settings, IP address, and registration information.
MGC IP Settings
The MGC registers with the Media Gateway, after which it receives its IP
address from the Media Gateway. After you register, the Link Status will
be
44
Table 5-5. MGP Config - QoS Parameters
Field
and an IP address will appear.
Up,
802 Priority and DSCP fields.
Description
The source of QoS control. This parameter can
only be changed via the CLI. Possible values are:
• Local - The processor is using the local
QoS parameters. The
fields can be configured.
• Remote - The processor is receiving QoS
parameters from the Media Gateway
Processor. All QoS parameters are Read-
only.
Priority based on a 802.1p standard, which
assigns rights and privileges to users of a
telephony network. Possible values are 0 - 7.
Priority based on a technology by which packets
are marked in the IP header Type of Service
(ToS) byte as belonging to a certain class.
Possible values range are 0 - 63.
802 Priority and DSCP
Avaya P330 Manager User Guide