JUKI IP-110 Instruction Manual page 5

7 Teachng swtch
8 Informaton swtch
9 Materal edge sensor
swtch
!0 One-shot sttchng swtch
!1 Wth/wthout automatc
thread trmmer swtch
!2 Thread trmmng
prohbtng swtch
!3 Counter value settng
swtch
!4 Max. speed lmtaton
varable resstor
!5 Power dsplay lamp
!6 Meda slot cover
!7 Meda slot (Meda nsertng openng)
Unused
Ths s the swtch to perform varous functon settngs.
Rendered effectve when the materal edge sensor s nstalled on
the machne.
Used for selectng whether or not the materal edge sensor s used
durng sewng.
When ths swtch s set to effectve, the sewng machne
automatically operates up to the specified number of stitches.
When ths swtch s set to effectve, the sewng machne
automatically performs thread trimming when the specified number
of sttches has been completed.
Ths swtch prohbts all thread trmmngs.
* Ths swtch cannot be used wth the sewng machne whch s not
provded wth the automatc thread trmmng devce.
Ths s the swtch to set the value of bobbn thread counter or No. of
pcs. counter.
When movng the resstor n the left drecton, max. speed s lmted.
Ths lamp lghts up when the power swtch s turned ON.
Ths s the cover for meda nsertng openng.
To open the cover, place your fingers on the notch located on the
side of the cover as shown in the figure and push the cover in the
drecton of left slantng rear.
* There are some functons that are not able to be operated
wth the cover opened. Do not close the cover unless the
CompactFlash(TM) s completely nserted.
To set the CompactFlash(TM), place the label face of the
CompactFlash(TM) to the front and nsert the part that has a small
hole (place the notch of the edge to the rear) to the panel.
To remove the CompactFlash(TM), hold it between your fingers and
draw t out.
* When the nsertng drecton of the CompactFlash(TM) s wrong,
the panel and the CompactFlash(TM) may be damaged. Do not
nsert anythng other than the CompactFlash(TM).
– 3 –