JUKI IP-110 Instruction Manual page 25

2) When edtng the next step, repeat tems 2) to ). When edtng ends, press swtch !3 to make ths
program effectve. (The llustraton above shows program off. When swtch !3 s pressed, the dsplay
changes as shown n the llustraton below, and the program becomes on.)
3) When swtch !6 s pressed to store ths program n memory and end the edtng, dsplay the screen of the
llustraton below. When swtch !5 s pressed, all contents of the edt up to that tme are nvaldated and
the state returns to that before edt.
14) Lastly, turn OFF the power switch. This simplified program works when the power switch is turned ON
agan.
¡ Insertng procedure of the step
When swtch !1 s pressed, a step (program command "DELY" s set) s newly nserted after the dsplayed
step, and the dsplay s changed over to that of the step.
¡ Deletng procedure of the step
When swtch !2 s pressed, the dsplayed step s deleted, the next step s advanced, and the dsplay s
changed over to that of the step.
¡ Effective simplified program No. display at the time of sewing
Smplfed program No. whch has been set effectve s dsplayed n the frame of dotted lne of the
illustration below in the normal sewing screen or the like, and which simplified program No. is working can
be confirmed. The illustration below shows the display when all of No. 1 to 4 are set effective. Simplified
program No. whch has been set nvaldate s not dsplayed.
Program off
Program on
– 23 –