JUKI IP-110 Instruction Manual page 23

) Press the respectve swtches to dsplay the screens of the respectve functons.
1 : Simplified program edit ............... Refer to the simplified program function.
2 : Optonal nput/output settng ....... Refer to the optonal nput/output functon.
3 : Thread trmmer devce dsplay ... Refer to the thread trmmer devce functon.
4 : Addtonal devce  settng .......... Refer to the addtonal devce functon.
5 : Addtonal devce 2 settng .......... Refer to the addtonal devce functon.
2) Press swtch 6 to return to the nformaton screen (mantenance personnel level), and press swtch 7 to
end the nformaton mode. Then the screen returns to that before the nformaton mode.
1. Simplified program function
This is the function to create the simplified program which takes in the various internal signals and the
sgnal from the outsde (connector), and can control the output of specal sgnals to the outsde (connector)
and the complcated moton of the sewng machne wth SC-50 man unt only wthout usng the exclusve
nput devce or the lke.
For the detaled operaton, refer to the Engneer's Manual for SC-50.
■ Simplified program edit the 1st screen
[Program command "END" : standard settng]
1
2
) Press swtches 1 and 2 to select programs (No.  to 4).
2) Press swtches 3 and 4 to select steps (No.  to 20). When the program command selected wth
swtches 5 and 6 s "END", the step No. becomes the last step and t s not possble to proceed to the
next step No.
3) Press swtches 5 and 6 to select the program command (Functon code Nos. 0 to 20). Here, select the
function code No. 2 "AND" as an example When "AND" is selected, the display is as shown in the figure below.
■ Simplified program edit the 1st screen
[Program command "AND" : standard settng]
4) Press swtches 7 and 8 to set parameter . Contents of parameter  may dffer or not exst dependng
on the selected program command.
5) Press swtches 9 and !0 to set parameter 2. Contents of parameter 2 may dffer or not exst dependng
on the selected program command.
6) Press swtch !4 to display the simplified program edit the 2nd screen.
3 5
4 6
7 9
!0
8
!4
– 2 –