Addtonal devce dsplay
Dsplay
Addtonal devce name
Functon code No.
MF auto-
hemmer devce
3-3. Setting for functions
(1) How to change over to the function setting mode
Do not perform switch operations other than those described in the following explanations.
Be sure to re-turn the power switch ON after one second or more has passed. If the power is turned
ON immediately after turning it OFF, the sewing machine may not work normally. In this case, turn ON
the power again.
WARNING :
To avoid possible personal injuries caused by movement other than that you desired, do not operate
the switches in the procedure other than those required, as described below, to specify the functions.
For the detals of settng No., see p.4.
) Turn ON the power.
Parameter functon
Name
Number of sttches
that makes the
sensor nvald at
sewng start settng
Number of sttches
count settng
2
Number of sttches of
condensaton output
settng
3
Number of sttches
of normal sttchng
settng
4
2
Parameter functon
Dsplay
Name
Functon code No.
(Number of
sttches)
00
0 to 999 : sttch
(Number of
sttches)
40
0 to 999 : sttch
(Number of
sttches)
5
0 to 999 : sttch
(Number of
sttches)
2
0 to 999 : sttch
– 4 –
Remarks
2) Press swtch
for
1
approxmately three
seconds.
1
3) Press swtch
for
2
approxmately three
seconds.