JUKI IP-110 Instruction Manual page 35

[Input function list]
When setting input function to input connector CN51, set the function signal to input to optional input
terminal to +5V (voltage) or less. When the input signal exceeds +5V or more, there is the possibility
that breakage or deterioration of the circuit board occurs. So, be careful. For the details, refer to the
Engineer's Manual for SC-510.
Functon dsplay
Functon code No.
No functon settng
0
Needle up/down
compensatng sttchng

Back compensatng
sttchng
2
Functon of cancel of once
of reverse sttchng at end
3
Thread trmmng functon
4
Presser lfter functon
5
One sttch compensatng
sttchng
6
Functon of cancel of
reverse sttchng at start
7
Functon of lftng presser
lfter when pedal s n
neutral poston

Materal end sensor nput
9
Functon of prohbton of
pressng front part of pedal
0
Functon of prohbton of
thread trmmng output

Functon name
: L nput
: L nput
: L nput
: L nput
: L nput
: L nput
: L nput
: L nput
: L nput
: L nput
: L nput
Input state settng
(Standard settng state)
-
Every tme swtch s pressed, as many
as half sttch s fed n normal drecton.
(Same moton as that of needle up/down
: H nput
compensatng sttchng swtch of the
operaton panel.)
Reverse sttchng at low speed s performed
whle swtch s held pressed.(Effectve
only when constant-dmenson sttchng s
: H nput
selected wth the operaton panel.)
Moton of reverse sttchng at end s not
executed once by depressng the back part
of pedal after pressng swtch.
: H nput
The functon works as thread trmmng
swtch.
: H nput
The functon works as presser lfter swtch.
: H nput
Every tme swtch s pressed, one sttch
sewng moton s executed.
: H nput
Invald/effectve can be alternately changed
over by operatng optonal swtch.
: H nput
Every tme swtch s pressed, functon of
automatcally lftng/not lftng presser lfter
when pedal s n neutral poston can be
: H nput
selected.
Ths functon works as nput sgnal of
materal end sensor.
: H nput
Ths functon prohbts rotaton by means of
pedal.
: H nput
Ths functon prohbts thread trmmng output.
: H nput
– 33 –
Descrpton of functon