JUKI IP-110 Instruction Manual page 40

2) Press swtches 2 and 3 to select the knd of addtonal devce.
3) Press swtch 5 to determne the selected devce. When swtch 4 s pressed, the selected devce s
nvaldated, and the state returns to that before selecton.
4) As an example, when selectng "TC0" (tape cutter devce [solenod type]), the screen dsplay changes as
shown below.
5) Press swtches 6 and 7 , and confrm parameter functons (No.  to 5) and the parameter set value
(dsplayed n the upper part of swtch 8 ) regardng addtonal devce "TC0" (tape cutter devce [solenod
type]). Knd of parameter functon and parameter set value depend on the addtonal devce to be
selected.
6) When changng parameter set value (dsplayed n the upper part of swtch 8 ), press swtches 6 and 7
to dsplay the parameter functon and the set value to be changed. Press swtch 8 to dsplay the screen
to change the parameter set value.
7) As an example, when changng parameter functon No.  (number of sttches of watng cutter moton at
sewng start), the screen dsplay changes as shown below.
) Press swtches !1 and !2 to change the parameter set value. When changng other parameter functon
No., press swtches 9 and !0 to select parameter functon No., and change the parameter functon No.
When changng has ended, press swtch !4 to return to the prevous screen. When swtch !3 s pressed,
the parameter set value s nvaldated, and the state returns to that before changng.
9) As an example, when changng parameter functon No.  (number of sttches of watng cutter moton at
sewng start) from 5 to , the screen dsplay s as shown below.
6
7 8
9 !1 !3
!0 !2 !4
!5
!6
– 3 –