Table 23: Summit WM Controller WM20 LED states and corresponding system states
System state
A component fails to start or needs restarting (Startup Manager
Task retrying that component)
Possible hardware failure (Fan, temperature)
A component fails (no more retries)
System about to reset by the watchdog
System shutdown/halt (Requires manual reboot)
NOTE
LED 3 – HDDActivity LED – Orange/Amber
• HDDActivity LED is off when HDD is not in use
• HDDActivity LED is on when HDD is in use
LED 4 – Hot Swap LED – Blue
• Solid Blue when the hot swap lever is pulled out
Summit WM Controller WM20 protocols
The Summit WM Controller WM20 uses similar protocols to the Summit WM Controller WM200/2000.
For more information, see
Summit WM Technical Reference Guide, Software Version 5.1
"Summit WM Controller WM200/2000 protocols" on page
Status LED
Activity LED
Solid Amber
Blinking Green
Green
Blinking Red
Solid Red
Off
Blinking Red
Off
Solid Red
Solid Red
72.
77