Termination Codes - Extreme Networks Summit WM Technical Reference Manual

Table 27: Information elements supported in RADIUS Stop or Interim messages (Continued)
Attribute
Session-Timeout
Class
Login-LAT-Group
Acct-Status-Type
Acct-Terminate-Cause
Acct-Authentic
Framed-IP-Address
Connect-Info
NAS-port-type
Called-Station-ID
Calling-Station-ID
Acct-Delay-Time
Acct-Session-Time
Acct-Input-Packets
Acct-Output-Packets
Acct-Input-Octets
Acct-Output-Octets
BP-Serial
BP-Name
WM-AD-Name
SSID

Termination Codes

The RADIUS client (Summit WM Controller or AP) terminates the wireless device user's session when
one of the following events occur:
user request
●
idle timeout
●
session timeout
●
administrator reset
●
When a user session is terminated, the RADIUS client sends a RADIUS accounting stop request that
will include one of the following termination codes:
Table 28: Termination codes
Radius Radius
Value Definition
1 User Request
Summit WM Technical Reference Guide, Software Version 5.1
NO. RAD. Data Type
27 integer
25 octets
36 octets
40 integer
49 integer
45 integer
8 ipaddr
77 string
61 integer
30 string
31 string
41 integer
46 integer
47 integer
49 integer
42 integer
43 integer
VSA string
VSA string
VSA string
VSA string
Controller
Value Controller/SMT Definition
9 RF notification that MU has
disconnected from Wireless AP. This
would be the case if there is a Logoff
button for Captive Portal. Normally
this would not apply to 802.1X
connections.
Name
(Accept-response/GUI input)
(Accept-response)
(Accept-response)
Stop/Interim-Update
Termination code (only in stop packet)
Radius/Local/Remote
Mu_ip_address
802.11 a[b][g]
18/19
BP MAC
mu_mac_address
Extreme-AP-Serial
Extreme-AP-Name
Extreme-WM-AD-Name
Extreme-SSID
Controller Name
MU_DEREG_REASON_USER
_REQUEST
129