Summit Wm Controller Wm200/2000 Protocols - Extreme Networks Summit WM Technical Reference Manual

Summit WM Controller diagnostics
Table 19: Summit WM Controller WM200/2000 application states (Continued)
Condition
MCE failure. Backup sectors
exhausted.
• Activity LED = Enabled
• Warning LED = Enabled
• Error LED = Enabled
• SSD= 7
NPE Initialization Failure.
Firmware self test (BIST) has
detected failure with one
component (memory, bus,
interconnects)
• Activity LED = Enabled
• Warning LED = Enabled
• Error LED = Enabled
• SSD= 8
SNMP Alarms are generated for each of the conditions corresponding to Major and Critical logs.

Summit WM Controller WM200/2000 protocols

The Summit WM software uses several protocols. All the protocols are IP based protocols, and as a
result have corresponding TCP and UDP ports associated with them. You must note the TCP/UDP
ports that are required for the proper functioning of the Summit WM Controller and the Wireless APs.
The following table specifies the protocol ports:
Table 20: Protocols and Ports
Component
Source
Controller
Controller
Access Point
Access Point
72
Log
Level
Protocol
Destination (TCP/UDP)
Access Point UDP
Controller TCP/UDP
Controller TCP
Controller TCP/UDP
TCP/UDP
Access Point UDP
Controller UDP
Controller UDP
Comment
Src Port Dst Port
Any 22
Any 5825
Any 161
32768-
65535
Any 13910
(Subject
to NAPT)
Any 13910
13907
Summit WM Technical Reference Guide, Software Version 5.1
Action
Contact Technical
Support to arrange
replacement.
Contact Technical
Support to arrange
replacement.
Service Remarks
CTP
SSH Management
HTTPS
SNMP
Outgoing connection
from the Controller
to various devices.
CTP WLAN data and
control tunnel.
CTP WLAN data and
control tunnel
RU
Registratio
n