Edit Existing Mfd Configuration - Ricoh GlobalScan Administrator's Manual

Edit Existing MFD Configuration

To modify the configuration of an MFD, for example, change the default profile, proceed as
follows:
1. Click the Manage MFDs
Manage MFDs Screen
•
Total Licenses Purchased
purchased CD Key.
•
Total Number of Enabled MFDs
communicate with the GlobalScan Server. The total number of enabled MFDs must be
equal to or less than the number specified by the license. For example, if you have a 10-
MFD license, the total number of enabled MFDs cannot exceed 10. If the total number of
enabled MFDs exceeds the maximum allowed, an error message is displayed.
•
Total Number of Disabled MFDs
communicate with the GlobalScan Server.
•
Total Number of MFDs
devices do not contribute to the total, only the number of enabled MFDs, thus the total
number of MFDs can be greater than the number specified by the license key.
•
Serial Number
numbers can be the same.
•
Profile Name
profile. The serial number will be associated with this profile. If you have changed the
default profile from the Manage MFDs screen, be sure to click the [Update] button to save
the setting.
menu link (or associated Home Page shortcut icon).
– Identifies the number of licensed MFDs based on the
– Identifies the number of MFDs that currently
– Identifies the number of MFDs that do not currently
– Identifies the total number of enabled MFDs. Note that disabled
(Required) – Identifies the MFD's serial number. No two MFD serial
(Required) – Click the drop-down button
GlobalScan
Administrator's Guide
[∨]
to select the MFD's default
TM
v3.1
131