Manage Status Detection - Ricoh GlobalScan Administrator's Manual

B.

Manage Status Detection

When the SmartDeviceMonitor for Client utility is installed on the GlobalScan Server, the
navigation pane will include a
allows you to set the maximum time period used by the GlobalScan Server to retrieve the status of
connected/enabled MFD(s).
To set the status detection time period, proceed as follows:
1. Click the

Manage Status Detection

Display reads:
2. Enter the values (in seconds). Note that both fields are required.
•
Maximum Time for Single MFD (seconds)
allowed for retrieving the status of an individual MFD. The valid range is 1 – 60 seconds.
•
Maximum Time for All MFDs (seconds)
allowed for detecting the status of all MFDs. The valid range is 0 – 600 seconds. Setting it
to zero (0) disables default status detection for all MFDs, while individual MFD status
refresh is still available on-demand by clicking on a traffic light. For more information about
MFD status and traffic lights, see About SmartDeviceMonitor (SDM).
3. Click the [Add] button, or if making changes to existing settings, click [Update].
4. Click the [Close] button or close the window [X].
Note: For information on SmartDeviceMonitor, see About SmartDeviceMonitor (SDM).
Manage Status Detection
menu link.
– This value represents the maximum time
menu link (circled below). This screen
– This value represents the maximum time
TM
GlobalScan v3.1
Administrator's Guide
140