A Glossary; Where To Go From Here; Instruction Manuals; 5522A Getting Started Manual - Fluke 5522A Operator's Manual

can write your own programs using the IEEE-488 command set or run the optional
Windows-based MET/CAL software. (See Chapter 6 for a discussion of the commands
available for IEEE-488 operation.)

Where to Go from Here

To locate specific information concerning the installation and operation of the 5522A
calibrator, refer to the following list:
Unpacking and setup: Chapter 2, "Preparing for Operation"
Installation and rack mounting: Chapter 2, "Preparing for Operation," and the rack
mount kit instruction sheet
AC line power and interface cabling: Chapter 2, "Preparing for Operation"
Controls, indicators, and displays: Chapter 3, "Features"
Front panel operation: Chapter 4, "Front Panel Operation"
Cabling to a UUT (Unit Under Test): Chapter 4, "Front Panel Operation"
Remote operation (IEEE-488 or serial): Chapter 5, "Remote Operation"
Calibrating an Oscilloscope: Chapter 8, "Oscilloscope Calibration Options"
Accessories to the 5522A Calibrator: Chapter 9, "Accessories"
Performance Specifications: Chapter 1, "Introduction and Specifications"

Instruction Manuals

The 5522A Manual Set provides complete information for operators. The set includes:
5522A Operators Manual on included CD-ROM (PN 3795084)
5522A Getting Started Manual (PN 3795091)
One of each manual listed above is shipped with the instrument. Order additional copies
of the manuals separately using the part number provided. For ordering instructions, refer
to the Fluke Catalog, or ask a Fluke sales representative (see "Service Information" in
Chapter 2).

5522A Getting Started Manual

This 5522A Getting Started Manual contains a brief introduction to the 5522A Manual
Set, instructions on how to get your calibrator prepared for operation and a complete set
of specifications.

5522A Operators Manual

This 5522A Operators Manual provides complete information for installing the 5522A
Calibrator and operating it from the front panel keys and in remote configurations. This
manual also provides a glossary of calibration, specifications, and error code information.
The Operators Manual includes the following topics:
Installation
Operating controls and features, including front panel operation
Remote operation (IEEE-488 bus or serial port remote control)
Serial port operation (printing, displaying, or transferring data, and setting up for
serial port remote control)
Operator maintenance, including verification procedures and calibration approach for
the 5522A
Oscilloscope calibration options
Accessories
Introduction and Specifications
Where to Go from Here
1
1-7