Table of Contents
Advertisement
Command
RTD_TYPE?
Returns the Resistance Temperature Detector (RTD) type.
Sets whether the internal temperature sensor or an external reference value is used for
TC_REF
Thermocouple (TC) outputs and measurements.
Returns the source and value of the temperature being used as a reference for
TC_REF?
thermocouple simulation and measurement.
TC_TYPE
Sets the thermocouple (TC) temperature type.
TC_TYPE?
Returns the thermocouple (TC) type.
TSENS_TYPE
Sets temperature sensor type when output is set to a temperature with OUT command.
TSENS_TYPE? Returns the temperature sensor type.
Commands
OL_TRIP?
Returns the detected state of scope overload protection.
OUT_IMP
Sets the output impedance of the SCOPE BNC.
OUT_IMP?
Returns the output impedance of the SCOPE BNC.
RANGE
Sets the Calibrator range when in OVERLD, PULSE, or MEASZ scope modes.
SCOPE
Sets the calibrator output to an oscilloscope mode.
SCOPE?
Returns the present oscilloscope mode.
TDPULSE
Activates or deacvitates the tunnel diode pulser drive for the –SC600 EDGE mode.
TDPULSE?
Returns whether the tunnel diode pulser drive for the –SC600 EDGE mode is active.
TLIMIT
Sets the time limit for –SC600 OVERLD mode to stay in operate.
TLIMIT?
Returns the time limit for –SC600 OVERLD mode to stay in operate.
Sets the power-up and reset default for the time limit for –SC600 OVERLD mode to stay
TLIMIT_D
in operate.
Returns the power-up and reset default for the time limit for –SC600 OVERLD mode to
TLIMIT_D?
stay in operate.
TMWAVE
Selects the waveform for MARKER mode.
TMWAVE?
Returns the timemark waveform setting for MARKER mode.
TRIG
Sets the frequency of the signal at the TRIG OUT BNC.
TRIG?
Returns the frequency of the signal at the TRIG OUT BNC.
Returns the last thermocouple, pressure, or, for the –SC600, impedance measurement
VAL?
value.
VIDEOFMT
Selects the format for VIDEO mode.
VIDEOFMT?
Returns the VIDEO mode format.
VIDEOMARK
Sets the VIDEO mode line marker location.
Table 6-3. External Connection Command (cont.)
Table 6-4. Oscilloscope Commands
Command Summary by Function
Description
Description
6
Remote Commands
6-5
Advertisement
Chapters
Table of Contents
