Table of Contents
Advertisement
5522A
Operators Manual
Safety Information
This Calibrator complies with:
In this manual, a Warning identifies conditions and actions that pose hazards to the user.
A Caution identifies conditions and actions that may damage the Calibrator or the
equipment under test.
Symbols used in this manual and on the Product are explained in Table 1.
Symbol
CAT I
To prevent personal injury:
To prevent possible electrical shock, fire, or personal injury:
1-4
10 MHz reference input and output. Use this to input a high-accuracy 10 MHz
reference to transfer the frequency accuracy to the 5522A, or to synchronize one or
more additional Calibrators to a master 5522A.
Simultaneous output of two voltages.
Extended bandwidth mode outputs multiple waveforms down to 0.01 Hz, and sine
waves to 2 MHz.
Variable phase signal output.
Standard IEEE-488 (GPIB) interface, complying with ANSI/IEEE Standards
488.1-1987 and 488.2-1987.
EIA Standard RS-232 serial data interface for printing, displaying, or transferring
internally stored calibration constants, and for remote control of the 5522A.
Pass-through RS-232 serial data interface for communicating with the Unit Under
Test (UUT).
ANSI/ISA-61010-1 (82.02.01)
CAN/CSA C22.2 No. 61010-1-04
ANSI/UL 61010-1:2004
EN 61010-1:2001
Description
IEC Measurement Category I – CAT I
is for measurements not directly
connected to mains. Maximum
transient Overvoltage is as specified
by terminal markings.
Conforms to European Union
directives
Risk of Danger. Important information.
See manual.
Earth ground
Use the Product only as specified, or the protection
supplied by the Product can be compromised.
Table 1-1. Symbols
Symbol
Conforms to relevant North American
Safety Standards.
Do not dispose of this product as unsorted
municipal waste. Go to Fluke's website for
recycling information.
Hazardous voltage
Conforms to relevant Australian EMC
requirements
Warning
Description
Advertisement
Chapters
Table of Contents
