Extreme Networks Summit X150 Series Hardware Installation Manual page 160

Building a SummitStack Configuration
To connect a SummitStack 64G/20G cable:
1 Connect the 64-Gbps connector to the VIM2 module as follows:
a Holding the cable connector with the release tab on top, align the connector with the stacking
port on the VIM2 module in the Summit X480 series switch
Figure 118: Connecting the 64G Connector
b Firmly press the cable connector into the stacking port until the spring latch on top of the
connector clicks into place.
2 Connect the 20G connector as follows:
a Align the cable connector with the stacking port connector on the back of the switch
b Firmly press the cable connector into place on the mating stacking port connector.
c Align and tighten the retaining screws on the cable connector.
Figure 119: Connecting the 20G Connector
160
SH_177
ES4K037
Summit Family Switches Hardware Installation Guide
(Figure 118).
(Figure 119).