Replacing A Summit X460 Fan Module - Extreme Networks Summit X150 Series Hardware Installation Manual

Maintenance Procedures for Summit X460 Series Switches

Replacing a Summit X460 Fan Module

You need a 1/2-inch flat-blade screwdriver to replace a Summit X480/X650 series fan module:
CAUTION
Be sure to finish the replacement procedure promptly. The switch may overheat if it is left without cooling
for an extended period.
To replace the fan module:
1 Completely loosen the captive retaining screws at the lower corners of the fan module
2 Slide the fan module out of the switch and set it aside.
Figure 221: Removing a Summit X460 Fan Module
3 Carefully slide the replacement fan module into the switch
Figure 222: Installing a Summit X460 Fan Module
4 Align and fully tighten the captive retaining screws.
266
SH_219
(Figure 222).
SH_220
Summit Family Switches Hardware Installation Guide
(Figure 221).