5
C H A P T E R
This chapter provides information about how to build and connect a SummitStack configuration. If you
intend to use the SummitStack feature, read this chapter before installing the set of Summit family
switches that will be included in the SummitStack configuration.
For instructions to install Summit family switches in equipment racks, see
The chapter includes the following topics:
Stacking Summit Family Switches on page 133
●
Placing Summit Family Switches for Stacked Operation on page 138
●
Connecting the Switches to Form the Stack Ring on page 141
●
Connecting Stacking Cables on page 151
●
Connecting Console Ports for a Stack on page 161
●
Management Port Cabling on page 162
●
Stacking Port LEDs on page 162
●
Stacking Summit Family Switches
A stack consists of a group of up to eight Summit switches that are connected together to form a
connected ring, as shown in
the following ways:
Using dedicated stacking connectors on the back of the switch; these ports are called native stacking
●
ports.
Using stacking-enabled 10-Gbps Ethernet ports, either at the front of the switch or on installed
●
option cards at the back of the switch. This type of stacking is called SummitStack-V stacking (see
"Choosing Between Native and Alternate Stacking Ports" on page
The stack can combine any Summit series switches that include support for stacking, as long as you
follow port compatibility and cabling recommendations. See
Stacked Operation" on page 138
more information about combining switches from different Summit series.
Summit Family Switches Hardware Installation Guide
Building a SummitStack
Configuration
Figure 92 on page
134. The stacking connections can be made in either of
and
"Connecting the Switches to Form the Stack Ring" on page 141
Chapter
6.
137).
"Placing Summit Family Switches for
for
133