Dhcp Relay Commands; Show Command_History; Config Dhcp_Relay - Extreme Networks EAS 100-24t Switch CLI Manual

Chapter 4: Management

show command_history

Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To display the command history:
#show command_history
Command: show command_history
?
? show
show vlan
show command history
#

DHCP Relay Commands

The DHCP Relay commands in the CLI are listed (along with the appropriate parameters) in the
following table:
Command

config dhcp_relay

config dhcp_relay add ipif
config dhcp_relay delete ipif
show dhcp_relay
enable dhcp_relay
disable dhcp_relay
Each command is listed, in detail, in the following sections:
config dhcp_relay
Purpose
Syntax
Description
Parameters
Restrictions
44
Used to display the command history.
show command_history
This command is used to display the command history.
None.
None.
Parameters
{hops <value 1-16> | time <sec 0-65535>}
[System] <ipaddr>
[System] <ipaddr>
{ipif [System]}
Used to configure the DHCP/BOOTP relay feature of the switch.
config dhcp_relay {hops <value 1-16> | time <sec 0-65535>}
This command is used to configure the DHCP/BOOTP relay feature.
hops <value 1-16> - Specifies the maximum number of relay agent hops that
the DHCP packets can cross. The default hops value is 4.
time <sec 0-65535> - If this time is exceeded; the switch will not relay the
DHCP packet. The default time value is 0.
Only Administrator-level users can issue this command.
Extreme Networks EAS 100-24t Switch CLI Manual