Chapter 5: Layer 2 Features
Example usage
To set the loopback detection status to enabled:
# config loopdetect ports 1-5 state enable
Command: config loopdetect ports 1-5 state enable
Success.
#
enable loopdetect
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable loopback detection on the switch:
# enable loopdetect
Command: enable loopdetect
Success.
#
disable loopdetect
Purpose
Syntax
Description
Parameters
Restrictions
144
Used to globally enable the loopback detection function on the switch.
enable loopdetect
This command is used to allow the loopback detection function to be globally
enabled on the switch. The default value is disabled.
None.
Only Administrator-level users can issue this command.
Used to globally disable the loopback detection on the switch.
disable loopdetect
This command is used to globally disable the loopback detection on the
switch. The default value is disabled.
None.
Only Administrator-level users can issue this command.
Extreme Networks EAS 100-24t Switch CLI Manual