Config 802.1X Auth_Parameter Ports - Extreme Networks EAS 100-24t Switch CLI Manual

Chapter 9: Security

config 802.1x auth_parameter ports

Purpose
Syntax
Description
Parameters
Restrictions
242
Used to configure the 802.1X Authentication parameters on a range of ports.
The default parameter will return all ports in the specified range to their default
802.1X settings.
config 802.1x auth_parameter ports [<portlist> | all] [default | {direction
[both | in] | port_control [force_unauth | auto | force_auth] | quiet_period
<sec 0-65535> | tx_period <sec 1-65535> | supp_timeout <sec 1-65535> |
server_timeout <sec 1-65535> | max_req <value 1-10> | reauth_period
<sec 1-65535> | enable_reauth [enable | disable]}]
This command is used to configure the 802.1X Authentication parameters on
a range of ports. The default parameter will return all ports in the specified
range to their default 802.1X settings.
<portlist> - Specifies a port or range of ports to be configured.
all - Specifies all of the ports on the switch.
default - Returns all of the ports in the specified range to their 802.1X default
settings.
direction [both | in] - Determines whether a controlled port blocks
communication in both the receiving and transmitting directions, or just the
receiving direction.
port_control - Configures the administrative control over the authentication
process for the range of ports. The user has the following authentication
options:
force_auth - Forces the Authenticator for the port to become authorized.
Network access is allowed.
auto - Allows the port's status to reflect the outcome of the authentication
process.
force_unauth - Forces the Authenticator for the port to become unauthorized.
Network access will be blocked.
quiet_period <sec 0-65535> - Configures the time interval between
authentication failure and the start of a new authentication attempt.
tx_period <sec 1-65535> - Configures the time to wait for a response from a
supplicant (user) to send EAP Request/Identity packets.
supp_timeout <sec 1-65535> - Configures the time to wait for a response from
a supplicant (user) for all EAP packets, except for the Request/Identity
packets.
server_timeout <sec 1-65535> - Configure the length of time to wait for a
response from a RADIUS server.
max_req <value 1-10> - Configures the number of times to retry sending
packets to a supplicant (user).
reauth_period <sec 1-65535> - Configures the time interval between
successive re-authentications.
enable_reauth [enable | disable] - Determines whether or not the switch will
re-authenticate. Enabled causes re-authentication of users at the time interval
specified in the Re-authentication Period field, above.
Only Administrator-level users can issue this command.
Extreme Networks EAS 100-24t Switch CLI Manual