Extreme Networks EAS 100-24t Switch CLI Manual page 263

config authen_enable
Parameters
Restrictions
Extreme Networks EAS 100-24t Switch CLI Manual
default – The default method list for administration rights authentication, as
defined by the user. The user may choose one or a combination of up to four
of the following authentication methods:
tacacs – Adding this parameter will require the user to be authenticated using
the TACACS protocol from the remote TACACS server hosts of the TACACS
server group list.
xtacacs – Adding this parameter will require the user to be authenticated using
the XTACACS protocol from the remote XTACACS server hosts of the
XTACACS server group list.
tacacs+ – Adding this parameter will require the user to be authenticated
using the TACACS+ protocol from the remote TACACS+ server hosts of the
TACACS+ server group list.
radius – Adding this parameter will require the user to be authenticated using
the RADIUS protocol from the remote RADIUS server hosts of the RADIUS
server group list.
server_group <string 15> - Adding this parameter will require the user to be
authenticated using a user-defined server group previously configured on the
switch.
local_enable - Adding this parameter will require the user to be authenticated
using the local user account database on the switch.
none – Adding this parameter will require no authentication to access the
switch.
method_list_name – Enter a previously implemented method list name defined
by the user (create authen_enable). The user may add one, or a combination
of up to four of the following authentication methods to this method list:
tacacs – Adding this parameter will require the user to be authenticated using
the TACACS protocol from a remote TACACS server.
xtacacs – Adding this parameter will require the user to be authenticated using
the XTACACS protocol from a remote XTACACS server.
tacacs+ – Adding this parameter will require the user to be authenticated
using the TACACS+ protocol from a remote TACACS+ server.
radius - Adding this parameter will require the user to be authenticated using
the RADIUS protocol from a remote RADIUS server.
server_group <string 15> - Adding this parameter will require the user to be
authenticated using a user-defined server group previously configured on the
switch.
local_enable - Adding this parameter will require the user to be authenticated
using the local user account database on the switch. The local enable
password of the device can be configured using the "config admin
local_password" command.
none – Adding this parameter will require no authentication to access the
administration level privileges on the switch.
Only Administrator-level users can issue this command.
Access Authentication Control Commands
263