Time And Sntp Commands - Extreme Networks EAS 100-24t Switch CLI Manual

Chapter 4: Management
Example usage:
To display the configuration of all ports on a standalone switch, with description:
#show ports description
Command: show ports description
Port State/
MDI Speed/Duplex/FlowCtrl
----- -------- ---------------------
1 Enabled Auto/Disabled
Auto
Desc:
2 Enabled Auto/Disabled
Auto
Desc:
3 Enabled Auto/Disabled
Auto
Desc:
4 Enabled Auto/Disabled
Auto
Desc:
5 Enabled Auto/Disabled
Auto
Desc:
6 Enabled Auto/Disabled
Auto
Desc:
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh

Time and SNTP Commands

The Simple Network Time Protocol (SNTP) (an adaptation of the Network Time Protocol (NTP))
commands in the CLI are listed (along with the appropriate parameters) in the following table.
Command
config sntp
show sntp
enable sntp
disable sntp
config time
config time_zone
config dst
show time
114
Settings
Speed/Duplex/FlowCtrl
---------------------
LinkDown
LinkDown
LinkDown
LinkDown
LinkDown
LinkDown
Parameters
{primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>} (1)
<date ddmmyyyy> <time hh:mm:ss>
{operator [+|-] | hour <utc_hour 0-13> | min <minute 0-59>} (3)
[disable | repeating {s_week <start_week 1-5,last> | s_day <start_day sun-sat>
| s_mth <start_mth 1-12> | s_time <start_time hh:mm> | e_week <end_week
1-5,last> | e_day <end_day sun-sat> | e_mth <end_mth 1-12> | e_time
<end_time hh:mm> | offset [30 | 60 | 90 | 120]} (9) | annual {s_date
<start_date 1-31> | s_mth <start_mth 1-12> | s_time <start_time hh:mm> |
e_date <end_date 1-31> | e_mth <end_mth 1-12> | e_time <end_time
hh:mm> | offset [30 | 60 | 90 | 120]} (7)]
Connection
Extreme Networks EAS 100-24t Switch CLI Manual
Address
Learning
--------
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled