Show Packet Ports; Show Error Ports; Example Usage - Extreme Networks EAS 100-24t Switch CLI Manual

Chapter 4: Management
Each command is listed, in detail, in the following sections:

show packet ports

Purpose
Syntax
Description
Parameters
Restrictions

Example usage:

To display the packets analysis for port 2:
#show packet ports 2
Command: show packet ports 2
Port Number : 2
Frame Size Frame Counts
------------ ------------
64 0
65-127 0
128-255 0
256-511 0
512-1023 0
1024-1518 0
Unicast RX 0
Multicast RX 0
Broadcast RX 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh

show error ports

Purpose
Syntax
Description
Parameters
Restrictions
90
Used to display stats about packets sent and received by the switch.
show packet ports <portlist>
This command is used to display statistics about packets sent and received by
ports specified in the <portlist>.
<portlist> - Specifies a port or range of ports to be displayed.
None.
Frames/sec Frame Type
---------- ----------
0 RX Bytes
0 RX Frames
0
0 TX Bytes
0 TX Frames
0
0
0
0
Used to display the error statistics for a range of ports.
show error ports <portlist>
This command is used to display all of the packet error statistics collected and
logged by the switch for a given port list.
<portlist> - Specifies a port or range of ports to be displayed.
None.
Total Total/sec
--------- ---------
0 0
0 0
0 0
0 0
Extreme Networks EAS 100-24t Switch CLI Manual