Enable Lldp; Purpose Syntax Description; Parameters Restrictions - Extreme Networks EAS 100-24t Switch CLI Manual

Chapter 4: Management
Command
disable lldp
config lldp
config lldp notification_interval
config lldp ports
config lldp forward_message
show lldp
show lldp mgt_addr
show lldp ports
show lldp local_ports
show lldp remote_ports
show lldp statistics
show lldp statistics ports
Each command is listed, in detail, in the following sections:

enable lldp

Purpose
Syntax
Description
Parameters
Restrictions
48
Parameters
[message_tx_interval <sec 5-32768> | message_tx_hold_multiplier <int 2-10> |
tx_delay <sec 1-8192> | reinit_delay <sec 1-10>]
<sec 5-3600>
[<portlist> | all] [notification [enable | disable] | admin_status [tx_only | rx_only |
tx_and_rx | disable] | mgt_addr [ipv4 <ipaddr>] [enable | disable] | basic_tlvs
[all | {port_description | system_name | system_description |
system_capabilities}] [enable | disable] | dot1_tlv_pvid [enable | disable] |
dot1_tlv_protocol_vid [vlan [all | <vlan_name 32>] | vlanid <vlanid_list>]
[enable | disable] | dot1_tlv_vlan_name [vlan [all | <vlan_name 32>] | vlanid
<vlanid_list>] [enable | disable] | dot1_tlv_protocol_identity [all | {eapol | lacp |
gvrp | stp}] [enable | disable] | dot3_tlvs [all | {mac_phy_configuration_status |
link_aggregation | power_via_mdi | maximum_frame_size}] [enable | disable]]
[enable | disable]
{[ipv4 <ipaddr>]}
{<portlist>}
{<portlist>} {mode [brief | normal | detailed]}
{<portlist>} {mode [brief | normal | detailed]}
{<portlist>}
Used to enable LLDP operations on the switch.
enable lldp
This command is used for global control of the LLDP function.
When this function is enabled, the switch can start to transmit LLDP packets
and receive and process the LLDP packets.
The specific function of each port will depend on the per port LLDP setting.
For the advertisement of LLDP packets, the switch announces the information
to its neighbor through ports. For the receiving of LLDP packets, the switch
will learn the information from the LLDP packets advertised from the neighbor
in the neighbor table.
The default state for LLDP is disabled.
None.
Only Administrator-level users can issue this command.
Extreme Networks EAS 100-24t Switch CLI Manual