Extreme Networks EAS 100-24t Switch CLI Manual page 273

config authen server_group
Purpose
Syntax
Description
Parameters
Restrictions
Extreme Networks EAS 100-24t Switch CLI Manual
Used to configure a user-defined authentication server group.
config authen server_group [tacacs | xtacacs | tacacs+ | radius | <string
15>] [add | delete] server_host <ipaddr> protocol [tacacs | xtacacs |
tacacs+ | radius]
This command is used to configure an authentication server group. A server
group is a technique used to group TACACS/XTACACS/TACACS+/RADIUS
server hosts into user defined categories for authentication using method lists.
The user may define the type of server group by protocol or by previously
defined server group. Up to eight authentication server hosts may be added to
any particular group
server_group - The user may define the group by protocol groups built into the
switch (TACACS/XTACACS/TACACS+/RADIUS), or by a user-defined group
previously created using the create authen server_group command.
tacacs – Use this parameter to utilize the built-in TACACS server protocol on
the switch. Only server hosts utilizing the TACACS protocol may be added to
this group.
xtacacs – Use this parameter to utilize the built-in XTACACS server protocol
on the switch. Only server hosts utilizing the XTACACS protocol may be
added to this group.
tacacs+ – Use this parameter to utilize the built-in TACACS+ server protocol
on the switch. Only server hosts utilizing the TACACS+ protocol may be
added to this group.
radius – Use this parameter to utilize the built-in RADIUS server protocol on
the switch. Only server hosts utilizing the RADIUS protocol may be added to
this group.
<string 15> - Enter an alphanumeric string of up to 15 characters to define the
previously created server group. This group may add any combination of
server hosts to it, regardless of protocol.
add/delete – Enter the correct parameter to add or delete a server host from a
server group.
server_host <ipaddr> - Enter the IP address of the previously configured
server host to add or delete.
protocol – Enter the protocol utilized by the server host. There are four
options:
tacacs – Use this parameter to define the protocol if the server host is using
the TACACS authentication protocol.
xtacacs – Use this parameter to define the protocol if the server host is using
the XTACACS authentication protocol.
tacacs+ – Use this parameter to define the protocol if the server host is using
the TACACS+ authentication protocol.
radius – Use this parameter to define the protocol if the server host is using
the RADIUS authentication protocol.
Only Administrator-level users can issue this command.
Access Authentication Control Commands
273