D-Link DES-6500 - Switch User Manual page 121

VLAN Name
Source IP
Destination IP
Port
To view the settings of a previously correctly configured rule, click
The following window is the CPU Interface Filtering Rule Table for Packet Content.
To remove a previously created rule, select it and click the
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Allows the entry of a name for a previously configured VLAN.
Source IP Address - Enter an IP Address mask for the source IP address.
Destination IP Address- Enter an IP Address mask for the destination IP address.
The Access Rule may be configured on a per-port basis by entering the port number of the line
card in the chassis into this field. The port list is specified by listing the lowest line card number
and the beginning port number on that line card, separated by a colon. Then the highest line
card number, and the highest port number of the range (also separated by a colon) are
specified. The beginning and end of the port list range are separated by a dash. For example,
1:3 specifies line card number 1, port 3. 2:4 specifies line card number 2, port 4. 1:3 - 2:4
specifies all of the ports between line card 1, port 3 and line card 2, port 4 − in numerical order.
Entering all will denote all ports on the Switch.
Figure 6- 82. CPU Interface Filtering Rule Display - IP
Figure 6- 83. CPU Interface Filtering Rule Table – Packet Content
in the Access Rule Table to view the following screen:
button. To add a new Access Rule, click the Add button:
106