D-Link DES-6500 - Switch User Manual page 108

To create a new rule set for an access profile click the Add button. A new window is displayed. To remove a previously created
rule, click the corresponding
Configure the following Access Rule Configuration settings for IP:
Parameter
Profile ID
Mode
Access ID
Type
Priority (0-7)
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Figure 6- 62. Access Rule Table window – IP
button.
Figure 6- 63. Access Rule Configuration window (IP)
Description
This is the identifier number for this profile set.
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that match the access profile are not forwarded by the
Switch and will be filtered.
Type in a unique identifier number for this access. This value can be set from 1 - 65535.
Selected profile based on Ethernet (MAC Address), IP address, Packet Content Mask or IPv6.
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
•
IP instructs the Switch to examine the IP address in each frame's header.
•
Packet Content Mask instructs the Switch to examine the packet header.
•
IPv6 instructs the Switch to examine the IPv6 part of each packet header.
•
This parameter is specified to re-write the 802.1p default priority previously set in the Switch,
which is used to determine the CoS queue to which packets are forwarded. Once this field is
specified, packets accepted by the Switch that match this priority are forwarded to the CoS
93