D-Link Single Ip Management; Single Ip Management (Sim) Overview - D-Link DES-6500 - Switch User Manual

D-Link Single IP Management

Single IP Management (SIM) Overview

Topology
Firmware Upgrade
Configuration Backup/Restore
Single IP Management (SIM) Overview
Simply put, D-Link Single IP Management is a concept that will stack switches together over Ethernet instead of using stacking
ports or modules. There are some advantages in implementing the "Single IP Management" feature:
1. SIM can simplify management of small workgroups or wiring closets while scaling the network to handle increased
bandwidth demand.
2. SIM can reduce the number of IP address needed in your network.
3. SIM can eliminate any specialized cables for stacking connectivity and remove the distance barriers that typically limit
your topology options when using other stacking technology.
Switches using D-Link Single IP Management (labeled here as SIM) must conform to the following rules:
SIM is an optional feature on the Switch and can easily be enabled or disabled through the Command Line Interface
•
or Web Interface. SIM grouping has no effect on the normal operation of the Switch in the user's network.
There are three classifications for switches using SIM. The Commander Switch (CS), which is the master switch of
•
the group, Member Switch (MS), which is a switch that is recognized by the CS a member of a SIM group, and a
Candidate Switch (CaS), which is a Switch that has a physical link to the SIM group but has not been recognized by
the CS as a member of the SIM group.
A SIM group can only have one Commander Switch (CS).
•
All switches in a particular SIM group must be in the same IP subnet (broadcast domain). Members of a SIM group
•
cannot cross a router.
A SIM group accepts up to 32 switches (numbered 0-31), including the Commander Switch (numbered 0).
•
There is no limit to the number of SIM groups in the same IP subnet (broadcast domain), however a single switch can only belong
to one group.
If multiple VLANs are configured, the SIM group will only utilize the default VLAN on any switch.
SIM allows intermediate devices that do not support SIM. This enables the user to manage switches that are more than one hop
away from the CS.
The SIM group is a group of switches that are managed as a single entity. The xStack DES-6500 chassis switch may take on three
different roles:
1. Commander Switch (CS) - This is a switch that has been manually configured as the controlling device for a group, and
takes on the following characteristics:
It has an IP Address.
•
It is not a command switch or member switch of another Single IP group.
•
It is connected to the member switches through its management VLAN.
•
2. Member Switch (MS) - This is a switch that has joined a single IP group and is accessible from the CS, and it takes on
the following characteristics:
It is not a CS or MS of another IP group.
•
It is connected to the CS through the CS management VLAN.
•
3. Candidate Switch (CaS) - This is a switch that is ready to join a SIM group but is not yet a member of the SIM group.
The Candidate Switch may join the SIM group of the xStack DES-6500 chassis switch by manually configuring it to be a
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Section 11
262