Stp Port Settings - D-Link DES-6500 - Switch User Manual

STP Port Settings

STP can be set up on a port per port basis. To view the following window click Configuration > Spanning Tree > STP Port
Settings:
In addition to setting Spanning Tree parameters for use on the switch level, the Switch allows for the configuration of groups of
ports, each port-group of which will have its own spanning tree, and will require some of its own configuration settings. An STP
Group will use the switch-level parameters entered above, with the addition of Port Priority and Port Cost.
An STP Group spanning tree works in the same way as the switch-level spanning tree, but the root bridge concept is replaced with
a root port concept. A root port is a port of the group that is elected based on port priority and port cost, to be the connection to the
network for the group. Redundant links will be blocked, just as redundant links are blocked on the switch level.
The STP on the switch level blocks redundant links between switches (and similar network devices). The port level STP will
block redundant links within an STP Group.
It is advisable to define an STP Group to correspond to a VLAN group of ports.
The following fields can be set:
Parameter
Unit
From/To
External Cost
Hello Time
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Figure 6- 26. STP Port Settings and Table window
Description
Choose the Switch ID number of the Switch in the switch stack to be modified.
A consecutive group of ports may be configured starting with the selected port.
External Cost - This defines a metric that indicates the relative cost of forwarding packets
to the specified port list. Port cost can be set automatically or as a metric value. The default
value is 0 (auto).
0 (auto) - Setting 0 for the external cost will automatically set the speed for forwarding
•
packets to the specified port(s) in the list for optimal efficiency. Default port cost:
100Mbps port = 200000. Gigabit port = 20000.
value 1-200000000 - Define a value between 1 and 200000000 to determine the
•
external cost. The lower the number, the greater the probability the port will be chosen
to forward packets.
The time interval between the transmission of configuration messages by the designated
port, to other devices on the bridged LAN, thus stating that the Switch is still functioning.
The user may choose a time between 1 and 10 seconds. The default is 2 seconds. This
field is only operable when the Switch is enabled for MSTP.
51