D-Link DES-6500 - Switch User Manual page 44

GVRP Status
Telnet Status
Telnet TCP Port
Number (1-65535)
Web Status
RMON Status
Link Aggregation
Algorithm
Switch 802.1x
Auth Protocol
HOL Prevention
Jumbo Frame
Syslog State
Click Apply to implement changes made.
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Use this pull-down menu to enable or disable GVRP on the Switch.
Telnet configuration is Enabled by default. If you do not want to allow configuration of the
system through Telnet, choose Disabled.
The TCP port number. TCP ports are numbered between 1 and 65535. The "well-known" TCP
port for the Web-interface protocol is 80.
Web-based management is Enabled by default. If you choose to disable this by selecting
Disabled, you will lose the ability to configure the system through the web interface as soon as
these settings are applied.
Remote monitoring (RMON) of the Switch is Enabled or Disabled here.
The algorithm that the Switch uses to balance the load across the ports that make up the port
trunk group is defined by this definition. Choose MAC Source, MAC Destination, MAC Src &
Dest, IP Source, IP Destination or IP Src & Dest (See the Link Aggregation section of this
manual for more information).
The Switch's 802.1x function may be enabled by port or by MAC Address; the default is
Disabled. This field must be enabled to view and configure certain windows for 802.1x. More
information regarding 802.1x, its functions and implementation can be found later in this
section, under the Port Access Entity folder.
Port-Based 802.1x specifies that ports configured for 802.1x are initialized based on the port
number only and are subject to any authorization parameters configured.
MAC-based Authorization specifies that ports configured for 802.1x are initialized based on the
port number and the MAC address of the computer being authorized and are then subject to
any authorization parameters configured.
The user may use the pull down menu to choose between radius eap and radius pap for the
802.1x authentication protocol on the Switch. The default setting is radius eap.
This field will enable or disable Head of Line Prevention on the Switch. The default is Enabled.
This field will enable or disable the Jumbo Frame function on the Switch. The default is
Disabled. The Switch supports Jumbo frames up to 9216 bytes.
Enables or disables Syslog State; default is Disabled.
29