D-Link DES-6500 - Switch User Manual page 116

Parameter
Profile ID (1-5)
Type
VLAN
Source IP Mask
Destination IP Mask
DSCP
Protocol
Click Apply to set this entry in the Switch's memory.
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Figure 6- 74. CPU Interface Filtering Configuration window- IP
Description
Type in a unique identifier number for this profile set. This value can be set from 1 - 5.
Select profile based on Ethernet (MAC Address), IP address or Packet Content Mask. This
will change the menu according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet header.
•
Select IP to instruct the Switch to examine the IP address in each frame's header.
•
Select Packet Content Mask to specify a mask to hide the content of the packet header.
•
Selecting this option instructs the Switch to examine the VLAN part of each packet header
and use this as the, or part of the criterion for forwarding.
Enter an IP address mask for the source IP address.
Enter an IP address mask for the destination IP address.
Selecting this option instructs the Switch to examine the DiffServ Code part of each packet
header and use this as the, or part of the criterion for forwarding.
Selecting this option instructs the Switch to examine the protocol type value in each frame's
header. Users must then specify what protocol(s) to include according to the following
guidelines:
Select ICMP to instruct the Switch to examine the Internet Control Message Protocol (ICMP)
field in each frame's header.
Select Type to further specify that the access profile will apply an ICMP type value, or
•
specify Code to further specify that the access profile will apply an ICMP code value.
Select IGMP to instruct the Switch to examine the Internet Group Management Protocol
(IGMP) field in each frame's header.
Select Type to further specify that the access profile will apply an IGMP type value
•
Select TCP to use the TCP port number contained in an incoming packet as the forwarding
criterion. Selecting TCP requires specification of a source port mask and/or a destination port
mask. The user may also identify which flag bits to filter. Flag bits are parts of a packet that
determine what to do with the packet. The user may filter packets by filtering certain flag bits
within the packets, by checking the boxes corresponding to the flag bits of the TCP field. The
user may choose between urg (urgent), ack (acknowledgement), psh (push), rst (reset),
syn (synchronize), fin (finish).
src port mask - Specify a TCP port mask for the source port in hex form (hex 0x0-
•
0xffff), which you wish to filter.
dest port mask - Specify a TCP port mask for the destination port in hex form (hex 0x0-
•
0xffff) which you wish to filter.
Select UDP to use the UDP port number contained in an incoming packet as the forwarding
criterion. Selecting UDP requires specification of a source port mask and/or a destination
port mask.
src port mask - Specify a UDP port mask for the source port in hex form (hex 0x0-
•
0xffff).
dest port mask - Specify a UDP port mask for the destination port in hex form (hex 0x0-
•
0xffff).
protocol id - Enter a value defining the protocol ID in the packet header to mask. Specify the
protocol ID mask in hex form (hex 0x0-0xffffffff).
101