D-Link DES-6500 - Switch User Manual page 120

The following window is the CPU Interface Filtering Rule Table for IP.
To create a new rule set for an access profile click the Add button. A new window is displayed. To remove a previously created
rule, click the corresponding
Configure the following Access Rule Configuration settings for IP:
Parameter
Profile ID
Mode
Access ID
Type
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Figure 6- 80. CPU Interface Filtering Rule Table – IP
button. The following window is used for the IP Rule configuration.
Figure 6- 81. CPU Interface Filtering Rule Configuration – IP
Description
This is the identifier number for this profile set.
Select Permit to specify that packets that match the access profile are forwarded by the Switch,
according to any additional rule added (see below).
Select Deny to specify that packets that match the access profile are not forwarded by the
Switch and will be filtered.
Type in a unique identifier number for this access. This value can be set from 1 - 100.
Selected profile based on Ethernet (MAC Address), IP address or Packet Content.
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
•
IP instructs the Switch to examine the IP address in each frame's header.
•
Packet Content Mask instructs the Switch to examine the packet header.
•
105