D-Link DES-6500 - Switch User Manual page 53

VLAN Name
Query Interval
Max Response Time
Robustness Value
Last Member Query
Interval
Host Timeout
Router Timeout
Leave Timer
Querier State
Querier Router
Behavior
State
Click Apply to implement the new settings. Click the
Snooping Group Entries window.
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
This is the VLAN Name that, along with the VLAN ID, identifies the VLAN for which to modify
the IGMP Snooping Settings.
The Query Interval field is used to set the time (in seconds) between transmitting IGMP
queries. Entries between 1 and 65535 seconds are allowed. Default = 125.
This determines the maximum amount of time in seconds allowed before sending an IGMP
response report. The Max Response Time field allows an entry between 1 and 25
(seconds). Default = 10.
Adjust this variable according to expected packet loss. If packet loss on the VLAN is
expected to be high, the Robustness Variable should be increased to accommodate
increased packet loss. This entry field allows an entry of 1 to 255. Default = 2.
This field specifies the maximum amount of time between group-specific query messages,
including those sent in response to leave group messages. Default = 1.
This is the maximum amount of time in seconds allowed for a host to continue membership
in a multicast group without the Switch receiving a host membership report. Default = 260.
This is the maximum amount of time in seconds a route is kept in the forwarding table
without receiving a membership report. Default = 260.
This specifies the maximum amount of time in seconds between the Switch receiving a leave
group message from a host, and the Switch issuing a group membership query. If no
response to the membership query is received before the Leave Timer expires, the
(multicast) forwarding entry for that host is deleted.
Choose Enabled to enable transmitting IGMP Query packets or Disabled to disable. The
default is Disabled.
This read-only field describes the behavior of the router for sending query packets. Querier
will denote that the router is sending out IGMP query packets. Non-Querier will denote that
the router is not sending out IGMP query packets. This field will only read Querier when the
Querier State and the State fields have been Enabled.
Select Enabled to implement IGMP Snooping. This field is Disabled by default.
Show All IGMP Snooping Entries
38
link to return to the Current IGMP